Roland VR-700 - Manual (Page 20)

22
Getting Ready
1. Make sure that the VR-700’s power is switched off.
2. Connect your USB memory to the VR-700’s rear panel
USB MEMORY connector.
fig.ConnectUSBmem.eps
• Never insert or remove a USB memory device while this unit’s power
is on. Doing so may corrupt the unit’s data or the data on the USB
memory.
• Carefully insert the USB memory all the way in—until it is firmly in
place.
• If you’re using new USB memory, you must first initialize (format) it
on the VR-700, refer to “Formatting USB Memory” (p. 62).
• For details on USB memory device that can be used with the VR-700,
refer to “Specifications” (p. 80). If you want to purchase USB
memory, please contact the retailer from whom you purchased the
VR-700.
Here’s how to attach the included music rest.
1. Remove the two music rest fastening screws from the
rear panel.
fig.MusicrestRemove.eps
2. Tighten the two screws to fasten the music rest in place.
fig.MusicrestAttach.eps
• When attaching the music rest, support it securely with your hand
so that it does not fall.
• Be careful not to pinch your hand or fingers when attaching the
music rest.
• Use only the included screws.
• To detach the music rest, support it with your hand and slowly
remove the screws. After detaching the music rest, firmly tighten
the fastening screws.
• The music rest fastening screws you remove must be kept out of the
reach of small children so that they will not be swallowed
accidentally.
Connecting USB Memory Attaching the Music Rest
VR-700_e.book 22 ページ ２００９年１１月１８日 水曜日 午前９時２４分