Roland VR-700 - Manual (Page 17)

19
Getting Ready
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction and/
or damage to speakers and other devices.
1. Before you turn on the power, make sure that the
[VOLUME] knob is turned all the way down.
Also minimize the volume of any connected external audio
equipment.
fig.VolMin.eps
2. To turn the power on, press the upper part of the
[POWER] switch located on the VR-700’s rear panel.
fig.P-On.eps
The power will turn on, and the display will light up.
* Minimize the volume before you turn on the power. Even if the
volume is minimized, you may hear sound when turning on the
power, but this does not indicate a malfunction.
* Due to a circuitry-protection feature, this unit requires a few
moments after it has been powered up before it is ready for normal
operation.
* If the power is turned off while a Factory Reset is being executed (p.
26), the internal data will be lost, and it may take some time to start
up the next time you switch on the VR-700’s power.
3. Switch on the power to any external equipment that is
connected.
4. Adjust the volume of any external equipment that is
connected.
5. Adjust the VR-700’s volume to an appropriate level.
1. Turn the [VOLUME] knob to the minimum position
before you turn off the power.
Also minimize the volume of any connected external equipment.
fig.VolMin.eps
2. Switch off the power to any connected external
equipment.
3. To turn the power off, press the lower part of the
[POWER] switch located on the VR-700’s rear panel.
* If you need to turn off the power completely, first turn off the
POWER switch, then unplug the power cord from the power outlet.
Refer to “Power Supply” (p. 6).
Turning the Power On/Off
Turning the Power On Turning the Power Off
VR-700_e.book 19 ページ ２００９年１１月１８日 水曜日 午前９時２４分