Roland SP-606 - Manual (Page 42)

42
Chapter 3. Sampling
Copyright law prohibits you from recording (sampling) copyrighted audio material belonging to a
third party without permission for any purpose other than personal enjoyment. Do not use this
device to make illegal recordings.
Roland Corporation accepts no responsibility for any damages or penalties you may be required to
pay as a result of making illegal recordings using Roland-manufactured equipment.
The following tables show the sampling time available with internal memory and with a memory card. In the
table, LONG and STANDARD indicate the Grade (p. 43) used when sampling.
The times shown below are for monaural sampling. If you sample in stereo, the available sampling time will be
half as long.
Internal memory
Memory card
If backup data (p. 70) is saved on the memory card, the sampling time available on the memory card
will be less.
Available Sampling Time
LONG STANDARD
Approx. 11 min. Approx. 5 min.
Card capacity LONG STANDARD
16 Mbyte Approx. 11 min. Approx. 5 min.
32 MByte Approx. 24 min. Approx. 12 min.
64 MByte Approx. 48 min. Approx. 24 min.
128 MByte Approx. 1 hour, 36 min. Approx. 48 min.
256 MByte Approx. 3 hours, 13 min. Approx. 1 hour, 36 min.
512 MByte Approx. 6 hours, 26 min. Approx. 3 hours, 13 min.
About SAMPLING GAIN
When you sample or resample, the sound may be distorted depending on the effect or mastering
settings. If this occurs, you can prevent distortion by adjusting the sampling gain to reduce the
volume at which the sound is being sampled.
1. From the SAMPLING STANDBY screen (p. 44), RESAMPLING STANDBY screen (p. 46, p. 47), or
EXT SEQ SMPL STANDBY screen (p. 48, p. 49), hold down [FUNC] and press [F3] (GAIN).
The SAMPLING GAIN setting will appear.
*
You can't access SAMPLING GAIN if the screen indicates “Select Pad.”
2. Turn the VALUE dial or use [DEC][INC] to adjust the “Sampling Gain” to a value from -12dB to
0dB.
3. Press [F3] (CLOSE) or [EXIT] to return to the Standby screen.
SP-606_e.book 42 ページ ２００４年６月２１日 月曜日 午前１０時８分