Roland SP-606 - Manual (Page 35)

35
Chapter 2. Using Effects
6. Press [F3] (SELECT) or [ENTER] to confirm your choice.
You will return to the MASTERING screen.
If you decide to cancel, press [EXIT].
Editing the Mastering Setup
7. Use [ ][ ] to select the parameter you want to edit.
Turn the VALUE dial or use [DEC][INC] to edit the parameter value.
8. If you want to save your settings, press [F3] (WRITE) to save them to “1 USER SET.”
9. The display will ask “System Write, Are You Sure?” To save your settings, press [F3] (EXEC) or [ENTER].
If you decide not to save your settings, press [F2] (CANCEL) or [EXIT].
Parameter Value Explanation
Spilt Freq 200–8000Hz Frequency at which the High and Low ranges are divided
In Level -24–0dB Mastering input volume
Low Attack 0.05–50ms Time over which compression is applied to the volume after the input exceeds the
Low Threshold
Low Release 0.05–2000ms Time over which compression is released after the input falls below the Low
Threshold
Low Threshold 0–127 Volume level at which compression begins to be applied to the low frequency
range
Low Ratio 1:1–inf:1 Compression ratio for the low frequency range (inf: infinite)
Low Level -24–+24dB Output volume of the low frequency compressor
High Attack 0.05–50ms Time over which compression is applied to the volume after the input exceeds the
High Threshold
High Release 0.05–2000ms Time over which compression is released after the input falls below the High
Threshold
High Threshold 0–127 Volume level at which compression begins to be applied to the high frequency
range
High Ratio 1:1–inf:1 Compression ratio for the high frequency range (inf: infinite)
High Level -24–+24dB Output volume of the high frequency compressor
List of Effects
MFX CTRL 1 CTRL 2 CTRL 3
1 FILTER + DRIVE CUTOFF RESO DRIVE
This is a low pass filter with
overdrive. It cuts the high-fre-
quency range and adds distor-
tion. Adjusts the frequency at which
the sound will be cut. Adjusts the amount of peak
(boost) applied to the region of
the cutoff frequency. Adds distortion.
2 REVERB REV TIME HF DAMP E.LEVEL
This is a reverb that cuts the re-
verb sound midway through
its decay. Adjusts the length of the rever-
beration. Adjusts the frequency at which
the high-frequency portion of
the reverb is cut. Adjusts the volume of the re-
verb sound.
3 DELAY DLY TIME FEEDBACK E.LEVEL
This is a stereo delay Adjusts the delay length ( *2 ) Adjusts the proportion of the
delayed sound that will be re-
turned to the input. Adjusts the volume of the de-
lay sound.
4 TAPE ECHO REPEAT INTENS E.LEVEL
This simulates a classic tape-
type echo unit. Adjusts the tape speed. Adjusts the number of echo re-
peats. Adjusts the volume of the echo
sound.
5 ISOLATOR LOW MIDDLE HIGH
Isolates or eliminates the low,
mid, or high-frequency re-
gions. Isolates/eliminates the low-
frequency range. Isolates/eliminates the mid-
frequency range. Isolates/eliminates the high-
frequency range.
SP-606_e.book 35 ページ ２００４年６月２１日 月曜日 午前１０時８分