Panel mounting, Figure 1-4. mounting the usb-621x on a panel, Panel mounting -5 – National Instruments Data Acquisition Device NI USB-621x User Manual

Page 22

Chapter 1

Getting Started

1-5

Panel Mounting

To mount the USB-621x to a board or panel, complete the following steps
while referring to Figure 1-4.

Figure 1-4. Mounting the USB-621x on a Panel

Note

Do not apply the rubber feet to the USB-621x when panel mounting the device.

Note

Apply strain relief, as described in the

section, before panel

mounting the USB-621x.

Download and print the panel mounting template PDF attached in the
KnowledgeBase document, USB-621x Panel Mounting Template.
Go to

ni.com/info

and enter the info code

ex3x98

to locate the

KnowledgeBase.

Using the template, mark the bottom point and top point on the panel.

(USB-621x Screw Terminal Devices)

The points will be 171.45 mm

(6.75 in.) from each other.

(USB-621x Mass Termination Devices)

The points will be 182.56 mm

(7.188 in.) from each other.