National Instruments Network Device DAQ S - Manual (Page 144)

Appendix A Device-Specific Information
NI 6124/6154 User Manual A-6 ni.com
Mating connectors and a backshell kit for making custom 68-pin cables are
available from NI.
NI recommends that you use one of the following connectors with the I/O
connector on your device.
• Honda 68-position, solder cup, female connector
• Honda backshell
• AMP VHDCI connector
For more information about the connectors used for DAQ devices, refer to
the KnowledgeBase document, Specifications and Manufacturers for
Board Mating Connectors, by going to
ni.com/info and entering the info
code rdspmb .
NI 6124 Specifications
Refer to the NI 6124 Specifications for more detailed information about the
device.