Equipping rules, Equipping rules 3-98 – Nortel Networks OPTera Metro 3500 User Manual
Page 326
3-98 Hardware feature descriptions
OPTera Metro 3500 Multiservice Platform NTRN10AN Rel 12.1 Standard Iss 1 Apr 2004
Alarm LED definitions
The following table provides a list of the OPTera Packet Edge 2xGigE circuit
pack LEDs. See
for the 2xGigE faceplate layout.
2xGigabit Ethernet/Fibre Channel - Point-to-Point circuit pack
(NTN438DA)
The 2xGigE/FC-P2P circuit pack also provides 2 independent LAN ports
allowing for transport of Gigabit Ethernet or Fibre Channel signals across a
SONET network where the traffic can be groomed, switched and monitored by
the network,
The 2xGigE/FC-P2P circuit pack allows a fiber LAN tributary interface to
connect directly to the circuit pack faceplate. The 2xGigE/FC-P2P circuit pack
supports contiguous and virtual concatenation connections, refer
Equipping rules
The OPTera Metro 3500 shelf supports eight OPTera Packet Edge
2xGigE/FC-P2P circuit packs in slots 3 through 10. 2xGigE/FC-P2P circuit
packs only operate in an unprotected mode.
Users can install only 2x100BT-P2P, 4x100BT, 4x100FX and 2xGigE/FC-P2P
circuit packs in adjacent slots.
LED
Color
Description
Status
Red
When active, indicates that a circuit pack
equipment failure has been detected.
Active
Green
When active, indicates that the circuit pack is
active and either at least one of the LAN ports is
IS (Data) or at least one cross-connect exists
(SONET).
WAN
Yellow
Active when the circuit pack has at least one
cross-connect and is attached to an OPTera
Packet Edge System ring and either the east,
west, or both WAN ports are experiencing an
STS path problem.
Link (1-2)
Yellow
Active when the administrative state of one of
the two LAN ports is up and the operational state
is down.