Nortel Networks OPTera Metro 3500 User Manual
Page 127
Operation, administration, and maintenance (OAM) features 2-89
Planning and Ordering Guide—Part 1 of 2 NTRN10AN Rel 12.1 Standard Iss 1 Apr 2004
WAN facility
, lists facility parameters supported by the
2xGigE/FC-P2P WAN interface.
Table 2-15
2xGigE/FC-P2P WAN port signal attributes
Signal Attribute
Definition
Access
(see Note
)
RATE
(Basic rate)
Is used to indicate the basic rate assigned
to that facility.
None,STS1, STS3C,
STS12C, STS24C
R/O
PROVUNITS
(Bandwidth units)
Is used to indicate the number of
provisioned bandwidth units in the
SONET/SDH transmit direction. The unit
is specified by the RATE attribute.
Possible values when VCAT=ENABLE
are 0..7 (when RATE is STS3c) or 0..21
(when RATE is STS1).
Possible values when
VCAT=DISABLE are 0 or 1.
Possible values when
VCAT=ENABLE are 0..7
(when RATE is STS3c) or
0..21 (when RATE is STS1).
R/O
ACTUALUNITS
(Units carrying traffic)
Is used to indicate the number bandwidth
unit actually carrying traffic in the
SONET/SDH transmit direction.
Possible values when
VCAT=DISABLE, or
VCAT=ENABLE and
LCAS=DISABLE are either 0
or PROVTXUNITS. It will
return UNKNOWN is the card
is not present in the shelf
R/O
MAGICNUM
(Magic number)
(See Note
Enables or disables the use of a magic
number to distinguish between two peers
and detect error conditions. Can be used
to determine whether trying to establish a
link with one self.
Disable
(See Note
)
R/O
FCS
(Frame checksum
size)
(See Note
Size of the FCS to be used to transmit
packets.
0, 32
(See Note
)
R/W
LCM
(Link connectivity
monitor)
(See Note
Is used to control the Link Connectivity
Monitor functionality.
Disable
(See Note
)
R/O
MAPPING
(Mapping protocol)
(See Note
Client signal to SONET mapping protocol GFP-F (default when LAN
facility is Ethernet),
GFP-T (default and only
option when LAN facility is
Fibre Channel)
R/W
MODE
(Mode)
Identifies if the port operates in SONET or
SDH mode.
Sonet, SDH
R/O
VCAT
(Virtual
Concatenation)
Indicates if Virtual Concatenation is
enabled or not on this port. Can only be
edited if there are no cross-connections.
Enable, Disable
(See Note
)
R/W