Nortel Networks Remote Gateway 50 - Manual (Page 83)

Bandwidth Management Page 83 of 258
Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide
CHG ZQRTI
Change the QoS Response Time Interval while alarms are not coming, in
order to increase the Sliding Maximum for the identified zone, where:
• Zone = 1-255
• Interval = interval in minutes = 1-(5)-120
CHG ZQUAT
Change the QoS Unacceptable Alarm Threshold value for the identified zone,
where:
• Zone = 1-255
• Thres = threshold value = 1-(75)-99
Note: When the zone-to-zone QoS value drops below the threshold value,
the alarm is presented. When the zone-to-zone QoS value is greater than this
threshold value, this alarm is presented as being deactivated. This value must
be below the value of ZQWAT.
CHG ZQWAT
Change the QoS Warning Alarm Threshold value for the identified zone,
where:
• Zone = 1-255
• Thres = threshold value = 1-(85)-99
Note: When the zone-to-zone QoS value drops below the threshold value,
the alarm is presented. When the zone-to-zone QoS value is greater than this
threshold value, this alarm is presented as being deactivated. The value for
ZQWAT must be higher than the value of ZQUAT.
LD 117 — Configure Adaptive Network Bandwidth Management. (Part 4 of 6)
Command Description