Nortel Networks Remote Gateway 50 - Manual (Page 37)

Setting up the main office Page 37 of 258
Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide
Main office information required by the SRG
The main office administrator must supply numerous main office settings to
the SRG installer so that the SRG can be efficiently configured. In addition,
the main office administrator needs to supply the following information:
• a list of the terminal record numbers (TNs)
• a list of BUIDs (Prime DNs)
• if using advanced routing, such as tandem dialing between systems, main
office routing (steering) codes, are required
Use Table 3 to record main office information required by the SRG.
Destination codes (steering codes) to route the main
office calls to the SRG and out through the SRG
PSTN lines
IP Ports that affect SRG traffic with the main office and
have been assigned firewall filters
For further information on port configuration, refer to
Converging the Data Network with VoIP (553-3001-
160) or SRG50 Configuration Guide.
Table 3
Main office interoperation information (Part 1 of 3)
Main office components Information about this system
Main office IP network information:
Main office call server type S1000 (default)
Primary network connect server address
Alternate network connect server
Network Connect server port
Table 2:
SRG information required for the main office configuration (Part 2 of 2)
SRG parameters