Nortel Networks Remote Gateway 50 - Manual (Page 47)

Setting up the main office Page 47 of 258
Main Office Configuration for Survivable Remote Gateway 50 Configuration Guide
Note: There is no automatic data synchronization between the main
office Call Server and SRG. The technician must provision the telephone
on both the Call Server and the SRG.
Branch office IP Phone configuration using OTM
At the main office, OTM can be used to configure branch office IP Phones.
Use Telephone Pages to configure the telephones to include the following:
• Terminal Type
• TN
• Customer Number
• Branch Office Zone
• Prime DN corresponding to the BUID
Refer to Optivity Telephony Manager: System Administration (553-3001-
330) for details.
Branch office IP Phone configuration using LD 11
Use Procedure 2 at the main office to configure branch office IP Phones.
Procedure 2
Configuring branch office IP Phones at the main office using LD 11
1 Configure the branch office zones and dialing plan. See Procedure 1 on
page 40 .
2 Configure the following telephone data in LD 11:
• Terminal type
• Customer Number
• TN