Appendix f: 2 x 10 pin field connector information – Navman 11 User Manual
Page 89
89
MN002000A © 2004 Navman NZ Ltd. All rights reserved. Proprietary information and specifications subject to change without notice.
APPENDIX F: 2 x 10 pin field
connector information
This appendix contains ordering information for the
2 x l0 pin field connector.
Note: The Pico modules have a different 2 x 10 pin
field connector to the one described below. Please
see the appropriate data sheet for details
PCB sockets
3M part number 20way 150220-6002-TB Digikey
part number 3M1020-ND
IDC ribbon cable sockets
AMP (Tyco) part number 20w 111626-4 Digikey
part number ASA20K-ND
APPENDIX G: RG-142 and RG-316
Specifications
This appendix provides technical specifications for
the RG-316 antenna cable used with the Jupiter
GPS receiver.
Typical Specification for RG-316:
I. Electrical Characteristics:
Nominal impedance 50 Ω
Nominal inductance 0.065 micro-h/ft
Nominal capacitance (conductor to shield) 29.0
pf/ft
Nominal velocity of propagation 69.5%
Nominal delay 1.48 pf/ft
Nominal attenuation 1500 Mhz
57.9 dB/100 ft
Nominal shield dc resistance at 20
o
C:
6.5 Ω/1000 ft
Nominal conductor dc resistance at 20
o
C:
33.0 Ω/1000 ft
Continuous working voltage 900 V RMS
II. Physical Characteristics:
Nominal weight 10 Ibs/1000 ft
Minimum bending radius 1.0 inch
Temperature rating –70 to +200
o
C
Type shield and percent coverage silver coated
copper
Inner braid, 96%
Outer braid, 96%
Maximum pulling tension 2lbs
Insulation material TFE Teflon*
Jacket material brown tint FEP Teflon*
Conductor diameter 0.020 inches nominal
Core diameter 0.58 inches nominal
Outside dimensions 0.96 inches nominal
Applicable specifications MIL-C-17F (M17/113-
RG316)
*Teflon is a trademark of DuPont