Nortel Networks Companion MICS-XC - Manual (Page 53)

P0881594 Issue 01 MICS-XC Norstar-Companion Installer Guide
Programming
Programming is performed by the installer or the customer
service representative, and it allows you to change settings for
the entire Norstar system, plus settings for individual
telephones and external lines. Most of the settings can also be
programmed by a system coordinator who has a “plus”
(SysCoord+) password. This password is distributed only by
the installer to avoid system complications.
Programming overview
Programming access is controlled by four passwords.
Installer password
Allows you to see and change any item in programming.
System Coordinator Plus password
Provides knowledgeable users with access to all but a few
sensitive areas of programming. It is usually distributed by
installers to System Coordinators that require special
programming access.
System Coordinator password
Used to view and change the settings that are part of day-to-
day administration of the Norstar system.
Programming affects system operation.
Only a qualified installer or customer service
representative should perform startup, installation and
maintenance programming. Some of the settings affect
the correct operation of the system.
p0881594.book Page 47 Tuesday, August 25, 1998 3:59 PM