Preparing cables, Figure 8, Cable stripping requirements for 8004dc – Nortel Networks 8000 Series User Manual
Page 34
34
Adding and replacing DC power supplies
313070-E Rev 00
Preparing cables
Nortel does not supply the cables for connecting the DC power supply to the DC
input power source. Select cables that comply with the electrical code of the
country where you will use the DC power supply.
If you ordered the optional breaker interface panel (BIP), Nortel ships the cables
for connecting the BIP to the 8004DC power supply. Go to
.
To prepare cables for connecting the power supply:
1
Strip 0.81 in. (2.1 cm) of insulation from the ends of the cables. See
for 8005DC.
Figure 8 Cable stripping requirements for 8004DC
Caution: You have the sole responsibility of ensuring that the
connection cable used with the DC power supply is appropriate for use
with the DC power source to which the power supply is connected.
Consider gauge, flammability, and mechanical serviceability when
determining which cables to use.
10296EA
0.81 in. (2.1 cm) 3 places
>
2
1
3
4
5
1 = Single-hole crimp lug
2 = Two-hole crimp lug
3 = Ground lead wire
4 = Positive lead wire
5 = Negative lead wire