2 arp table setting, 1 adding static arp table entries – Planet Technology Planet Intelligent Gigabit Ethernet Stackable/Routing Switch WGSW-2402A User Manual
Page 95
- 87 -
5.6.2 ARP Table Setting
If you select ARP Table from the IP Networking screen in Figure 5-47, an ARP Table screen similar to
the following appears with the ARP table entries that have been already defined or learned.
F
IGURE
5-47
From this screen, you can:
Add static entries to the ARP table. See section 5.6.2.1 “Adding Static ARP Table Entries”.
Delete static entries from the ARP table. See section 5.6.2.2 “Deleting Static ARP Table Entries”.
Search for entries in the ARP table. See section 5.6.2.3 “Searching for ARP Table Entries”.
5.6.2.1 Adding Static ARP Table Entries
To add static entries to the ARP table:
1. From the ARP Table screen, hold down the Shift key and press +. The Static ARP Specifications
screen appears, with the highlight in the Internet Address field.