Planet Technology Planet Intelligent Gigabit Ethernet Stackable/Routing Switch WGSW-2402A - Manual (Page 121)

- 113 -
3. Use the Down Arrow key to highlight Bridge Priority and press Enter. The Enter Bridge Priority
screen appears. Bridge priority is used in selecting the root device, root port, and designated port.
The device with the highest priority becomes the STA root device. However, if all devices have the
same priority, the device with the lowest MAC address will then become the root device. Default
is 32768. Enter a value from 0 - 65535. Remember that the lower the numeric value, the higher
the priority
F IGURE 5-84
4. Type a decimal number for the bridge priority and press Enter. The decimal value you typed
appears next to Bridge Priority.
5. Use the Down Arrow key to highlight Hello Time (sec) and press Enter. The Enter Hello Time
screen appears. This is time interval (in seconds) at which the root device transmits a
configuration message. Default is 2. The minimum value is 1. The maximum value is the lower
of 10 or [(Max. Message Age / 2) -1].