Planet Technology Planet Intelligent Gigabit Ethernet Stackable/Routing Switch WGSW-2402A - Manual (Page 280)

- 272 -
Appendix D VLAN Overlapping
In some situation, two or more workgroups need to connect to same servers but should not allow them
to connect each other. For example, port 3 ~ port 5 are one workgroup and port 6~8 are another
workgroup. Both of them need to connect Servers on port 1 and 2. In this situation, we need to
configure PVID and create VLAN groups as the following table:
T ABLE D -1 PVID AND VLAN CONFIGURATION
1 2 3 4 5 6 7 8
PVID 100 100 200 200 200 300 300 300
VLAN 100 U U U U U U U U
VLAN 200 U U U U U
VLAN 300 U U U U U
The configuration on the console interface should be as the following:
1. Create three VLAN with VLAN ID 100, 200 and 300.
F IG D-1 VLAN G ROUP
2. VLAN 100 consist port 1 to port 8 as untagged.