Planet Technology Planet Intelligent Gigabit Ethernet Stackable/Routing Switch WGSW-2402A - Manual (Page 75)

- 67 -
F IGURE 5-23
b. To configure an individual port, highlight it and press Enter. An asterisk appears next to each
port you select. (To deselect it, press Enter again to remove the asterisk.)
To configure all ports, highlight All Ports and press Enter.
c. Press Esc. The port(s) you selected appear in the previous screen.
3. When you finish, press Esc until you return to the desired screen.
5.2.2.7 Deleting Ports
The following procedure describes how to delete ports from a VLAN. There is no precautionary
message that appears before you delete a VLAN port, so be sure you want to delete the port before
doing so.
1. From the screen, use the Up and Down Arrow keys to highlight the port you want to delete.
2. Press the - (hyphen) key. The port is deleted.
3. When you finish, press the Esc key until you return to the desired screen.
5.2.3 Configuring PVID
The PVID provides identification to the port of VLAN. The Switch will tag with this ID to any incoming