Promise Technology FastTrak SX Series Version 4.4 - Manual (Page 74)

Promise Array Management
70
Conversion
Converting changes its RAID Level, and in some cases increases the array
capacity, without affecting data availability. Depending on the source and target
RAID levels, you can add one or more free disk drives while performing the
Convert function.
Note
• With most operating systems, expanding an array will
require you to partition the added space with a new drive
letter. In effect, you will end up with two arrays.
• Plan to run your conversion during off hours. This will
eliminate delayed read-write response from the array and
allow the process to go faster.
FastTrak S150 SX4 and SX4000 support the following RAID Conversions.
From To Comments
RAID 5 RAID 0 Increases the capacity and performance but loses the
data redundancy.
RAID 5 Adds performance, capacity and redundancy. 3 or 4
drives required.
RAID 0+1 Adds performance and capacity. 4 drives required.
RAID 1
RAID 0 Increases capacity and performance but loses data
redundancy. Must add a drive.
RAID 5 Adds performance, capacity and parity. 3 or 4 drives
required. RAID 0
RAID 0+1 Adds full redundancy and capacity. 4 drives required.
Important
• No existing array can convert to RAID 1.
• RAID 0+1 arrays cannot convert to another RAID level.
• The Target array may require more disk drives than the
Source array.
• You cannot reduce the number of disk drives in your array.