5 charge indicators, 6 troubleshooting, 5 charge indicators 6.6.6 troubleshooting – Psion Teklogix Hand-Held Computer 7530 G2 User Manual
Page 249: Table 6.2 combo charger indicators
Psion Teklogix 7530 G2 Hand-Held Computer User Manual
221
Chapter 6: Peripheral Devices & Accessories
Charge Indicators
6.6.5 Charge Indicators
The spare battery charge slot has an associated tri-colour LED indicator on the
lower-right area of the front panel.
Table 6.2 Combo Charger Indicators
The combo charger supplies DC power to enable the 7530 G2 internal fast charger.
Charge status is displayed on the 7530 G2 charge LED – the lower-right LED. Refer
to “Charge LED” on page 43 for details.
Normally, it takes from 1.5 to 4.0 hours to fully charge the 7530 G2 internal battery.
Note: Battery charging continues whether the 7530 G2 is switched on or off.
6.6.6 Troubleshooting
The gang charger troubleshooting section also applies to the combo charger. Refer
to “Troubleshooting” on page 218, for helpful tips.
LED Behaviour
Charge Status
Off
No battery detected in the slot.
Solid green
Battery is fully charged.
Flashing green
Battery is charged to 75% capacity.
Solid yellow
Charge in progress.
Flashing yellow
Battery temperature outside the charge range of between
5° C to 39° C (41° F to 102° F). Charging is attempted
every five minutes until the battery is within the appropriate
temperature range.
Solid red
Battery rejected (at insertion) or unable to complete charge
on battery.
Flashing red
Charging circuit problem. Refer to “Troubleshooting” on
page 218 for details.