Introduction, Connecting the ipdslam to your pc, Connecting and logging in via the ethernet port – Patton electronic 3224 User Manual
Page 32
Introduction
25
Model 3224 G.SHDSL IpDSLAM User Manual
3 • Initial configuration
Introduction
This chapter leads you through the basic steps to set up a new Model 3224 G.SHDSL IpDSLAM. Setting up a
new Model 3224 IpDSLAM consists of the following main steps:
Note
If you haven’t already installed the IpDSLAM, refer to chapter 2,
•
Connecting the IpDSLAM to your laptop PC
•
Configuring the desired IP address
•
Connecting the IpDSLAM to the network
1. Connecting the IpDSLAM to your PC
First the IpDSLAM must be connected to the mains power supply with the power cable (see
on page 16). Wait until the Power LED stops blinking and stays lit constantly. Now the IpDSLAM is
ready.
Connecting and logging in via the Ethernet port
The IpDSLAM is equipped with Auto-MDX Ethernet ports, so you can use straight-through cables for host or
hub/switch connections (see
Figure 13. Connecting the IpDSLAM to your laptop PC via the Ethernet port
1. To access the configuration, connect a PC’s Ethernet port to the unit’s LAN port. Use the black Ethernet
cable included with your IpDSLAM for this purpose.
2. Configure your PC’s Ethernet port to be on the same subnet as the IpDSLAM.
The interconnecting cables shall be acceptable for external use
and shall be rated for the proper application with respect to volt-
age, current, anticipated temperature, flammability, and
mechanical serviceability.
CAUTION
PC
Connect to Ethernet LAN
ports, ETH 0 and ETH 1
Model 3224
192.168.200.10
Ethernet port