Patton electronic 3224 - Manual (Page 25)

Cable installation 18
Model 3224 G.SHDSL IpDSLAM User Manual 2 • Hardware installation
Installing the power cables—AC power supply
This section describes installing the female end of the power cables into the IEC-320 connectors on the
IpDSLAM. Do not connect the male end of the power cables to the power outlet at this time.
Do the following:
To avoid the risk of injury from electric shock, the power cords connected to
the IEC-320 connectors must be grounded power cords.
The IpDSLAM power supply can be configured for 115 or 230
VAC operation. By default, the 3224/230 IpDSLAM is set to
230 VAC and the 3224/115 is set to 115 VAC. If you need to
change the voltage setting for your power supplies, contact your
Patton distributor or Patton Electronics technical support.
Verify that the proper voltage is present before plugging the
power cord into the receptacle. Failure to do so could result in
equipment damage.
The Model 3224 can only be configured with two AC power
supplies or two DC supplies, you cannot mix AC and DC sup-
plies in the same chassis.
The Model 3224 does not have a power switch, so it will acti-
vate upon connection to a power source.
The AC main socket outlet must be located within 10 feet
(3 meters)
WARNING
CAUTION
CAUTION
CAUTION
CAUTION