Pitney Bowes ADDRESSRIGHT DA700 - Manual (Page 43)

3-15 SV61027 Rev. D
DA700/DA750 Features and Adjustments • 3
5. Position the Feed Fence
Your printer comes with two feed fences—a long one and a
short one. Use the long fence for #10 envelopes and larger
materials. Use the short fence for materials smaller than a
#10 envelope.
It is important that the sliding fence not be adjusted tight
against the media.
To position the fence:
1. Place a sample piece or trial stack of material in the
input area.
2. Slide the fence until it almost touches the stack of
material.
3. Check that there's about 1/16" clearance (the thick-
ness of a dime) between the fence and the stack.
NOTE: Proper clearance is important. If you push the
fence tight up against the stack, it could retard feeding
and cause jams. If the clearance is too great, pieces
could skew as they feed into the printer.
Setting Up A Job
(continued)
Adjust Sliding Fence
to media width.