Pitney Bowes ADDRESSRIGHT DA700 - Manual (Page 3)

i SV61027 Rev. D
Table of Contents
Chapter 1, DA700/DA750 Overview
Welcome to the DA700/DA750 ...................................... 1-2
Using This Guide ........................................................... 1-2
System Requirements ................................................... 1-4
Getting Help .................................................................. 1-5
Online Help .............................................................. 1-5
Phone Support ......................................................... 1-5
Before You Call ........................................................ 1-5
The World Wide Web ............................................... 1-6
Printer Options .............................................................. 1-7
Ordering Supplies .......................................................... 1-7
Chapter 2, Getting Started with the DA700/DA750
Unpacking the Printer .................................................... 2-2
Package Contents ................................................... 2-3
Choosing a Location for Your Printer ............................. 2-4
Important Safety Notes .................................................. 2-4
Assembling the DA700/DA750 ...................................... 2-5
1. Attach the Wire Frame to the Printer ................... 2-6
2. Install the Sliding Fence ...................................... 2-7
3. Position the Output Stacker Tray ......................... 2-8
4. Connect the Parallel Cable or Serial Cable ......... 2-9
5. Connect the Power Cord ..................................... 2-11
Turning On the DA700/DA750 Printer ........................... 2-11
Install the Ink Jet Cartridges (Color & Black) ................. 2-12
Removing the Ink Jet Cartridges ................................... 2-13
Chapter 3, DA700/DA750 Features and Adjustments
Printer Features ............................................................. 3-2
DA700/DA750 Throughput ...................................... 3-3
Material Thickness ................................................... 3-4
Media Size ............................................................... 3-4
Approved Media Types ............................................ 3-4
Setting Up a Job ............................................................ 3-6
1. Set the Separator Gap ......................................... 3-9
2. Center the Wireframe under the Material ............ 3-12