Dualflow dsu configuration worksheet (1 of 2) – Paradyne COMSPHERE 3615 User Manual
Page 90
DualFlow DSU Configuration Worksheet (1 of 2)
Date:_____________________________________________
Location:____________________________________________
Local Phone No: (
j
)_____________________________
Device:___________________________________________
Local Addr:__________________________________________
Serial No:_________________________________________
Tributary Network Addr: ________________________________
DSU
Value
Rate(Kbps)
64CC, 64L, 56, 38.4, 19.2, 9.6, 4.8, 2.4
TxClkSource
Int, RXC, Ext, DDS
19.2 PowrLvl
+ 6, 0, –10
64KScramblng
On, Off
64KLatchLpbk
On, Off
V.54 Lpbk
Enab, Disab
Hardware Straps
Value
DDD Interface *
Permissive, Programmable
Frame Ground/
Signal Ground
Connected, Disconnected
Test Mode Indication
Enabled, Disabled
{
V.32 DBM only
* Switched 56 DBM only
{{
Only if Call Setup set to Pswrd
** 2-wire Switched 56 DBM only
DSU Port (V.35)
Value
DTE Port
V.35
RTS Cntrl
FrcOn, DTE
CTS Cntrl
Std, =RTS, Delay, FrcOn
AntiStream
(Chang)
Disab (1–100 sec)
LSD Lead
Std, Delay, FrcOn
DSR FrcOn
Enab, Disab
SystemStat
Enab, Disab
DSR on Tst
Enab, Disab
Circ Assur
Enab, Disab
RespondRDL
Enab, Disab
LL by DTE
Enab, Disab
Bilat Lpbk
Enab, Disab
DTR Alarm
Enab, Disab
DBM
Value
Rate(Kbps)
{
14.4, 12.0, 9.6, 4.8, 2.4
PrtSp(Kbps)
56, 48, 38.4, 32, 28.8, 19.2, 18.8, 18.0,
16.8, 14.4, 12.0, 9.6, 9.2, 8.4, 7.2, 4.8, 4.4,
4.0, 2.4, 2.0, 1.2, Disab
TxClkSource
{
Int, RXC, Ext
CarrLossDisc
{
Yes, No
Auto Retrain
{
Yes, No
Single Rate
{
Yes, No
AutoAnswer
Enab, Disab
Call Setup
None, Pswrd, Cllbk, Alarm
RxPwd
{{
(Chang)
(up to 10 digits)
TxPwd
{{
(Chang)
(up to 10 digits)
Dial Test
Enab, Disab
Primary Core
Yes, No
DTRCallCon
Orig, Ansr, Disab
EchoCancel *
Enab, Disab
Remot DBM **
2-wire, 4-wire
Msg Clamp
Enab, Disab