Pride Mobility ACN# 088 609 661 - Manual (Page 32)

32 Basic Operation Instructions
Synergy Seat www.pridemobility.com
Two Post Height Adjustable Flip-Up Armrests
The height adjustment range for the Two Post Height Adjustable Flip-Up
Armrest is 4 in. (10.16 cm) in 1-in. (2.54-cm) increments. The total height
adjustment range is 10–14 in. (25.4–35.56 cm). This range is measured from
the top of the seat rail to the top of the arm pad. You can also flip the arm-
rests up or remove them for transfer. See figure 28.
To remove the armrest assembly:
1. Push the spring-loaded lever downward and pull up on the front of the
armrest. See figure 28.
2. Remove the detent pin from the back of the seat. See figure 28.
3. Pull up on the rear of the armrest to remove the assembly.
To install the armrest assembly:
1. Set the rear of the armrest into the rear seat receiver and install the detent
pin. See figure 28.
2. Rotate the armrest assembly down.
3. Push the front of the armrest into the front seat receiver and rotate the
spring-loaded lever to the horizontal position to lock into place.
Figure 28. Two Post Height Adjustable Flip-Up Armrest Removal and
Installation
Detent Pin
Spring-loaded Lever