Polaris Magnum 330 - Manual (Page 62)

59
OPERATION
Break-In Period
The break-in period for your new Polaris 4-cycle ATV is defined as the
first ten hours of operation, or the time it takes to use the first two full
tanks of gasoline. No single action on your part is as important as
following the procedures for a proper break-in. Careful treatment of a
new engine will result in more efficient performance and longer life for
the engine. Perform the following procedures carefully.
1. Fill the fuel tank with
gasoline. See page 45.
2. Check the oil level on
the dipstick. See page
86. Add Polaris
Premium 4 Synthetic Oil if
necessary to maintain the oil
level in the normal/safe operating
range (1).
3. Drive slowly at first. Select an
open area that allows room to familiarize yourself with vehicle
operation and handling.
4. Vary throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and areas outlined
on the daily pre-ride inspection checklist. See page 60.
6. Pull only light loads.
7. During the break-in period, change both the oil and the filter at 20
hours or 200 miles.
CAUTION
Excessive heat build-up during the first three hours of
operation will damage close-fitted engine parts. Do not operate
at full throttle or high speeds for extended periods during the
first three hours of use.
Use of any oils other than those recommended by Polaris may
cause serious engine damage. We recommend the use of
Polaris Premium 4 Synthetic Oil for your 4-cycle engine.
ADD 8 OZ. NORMAL FULL
1
1
500
330