Polaris Magnum 330 - Manual (Page 101)

98
MAINTENANCE AND LUBRICATION
Engine Cooling System (Magnum 500)
Radiator Coolant Level
NOTE: This procedure is required
only if the cooling system has been
drained for maintenance and/or repair.
However, if the recovery bottle has
run dry, inspect the level in the
radiator and add coolant if necessary.
1. Using the tool provided, remove
the four screws (1) securing the
front rack or storage box.
Remove the front cover (2) by
placing your fingers under the
front of the cover and pulling
upward.
2. Remove the pressure cap.
3. Using a funnel, slowly add coolant
as necessary through the radiator
filler neck.
4. Replace the pressure cap and
secure the front cover.
NOTE: Use of a non-standard
pressure cap will not allow the
recovery system to function properly.
Contact your dealer for the correct
replacement part.
WARNING
Escaping steam can cause severe burns. Never remove the
pressure cap while the engine is warm or hot. Always allow the
engine to cool before removing the pressure cap.
2
1
Models with rack
2
1
Models with
storage box