Polaris Magnum 330 - Manual (Page 120)

117
MAINTENANCE AND LUBRICATION
Adjustments
Handlebars
The handlebars can be adjusted for
rider preference.
1. Remove the upper headlight pod
(Magnum 500) or handlebar cover
(Magnum 330).
2. Loosen the four handlebar
bolts (1).
3. Adjust the handlebar to the
desired height. Be sure the
handlebars do not contact the
gas tank or any other part of the
machine when turned fully to
the left or right.
4. Torque the front two bolts to
10-12 ft. lbs. (14-17 Nm), then
torque the rear two bolts. A gap
of up to 1/8” will remain at the
rear bolts.
Improper adjustment of the handlebars or incorrect torquing of
the adjuster block tightening bolts can cause limited steering or
loosening of the handlebars, resulting in loss of control and
possible serious personal injury or death. Follow the adjustment
procedures exactly, or see your Polaris dealer for service.
WARNING
1
1