Polaris Magnum 330 - Manual (Page 105)

102
MAINTENANCE AND LUBRICATION
Lights
Headlight Housing Replacement (Magnum 500)
1. Remove the three screws on the headlight pod.
2. Using a small flat-blade screwdriver, push in on the lock tabs
through the two small openings at the front of the headlight pod.
Lift the pod lightly while depressing the tabs.
3. Lift the pod cover. Disconnect the speedometer harnesses from the
speedometer. Unplug the indicator light harness and remove the
pod cover.
4. Unplug the headlamp from the wiring harness.
5. Pull the headlight housing up to release from the locking tabs.
6. Lift the adjusting knob up to remove from the locking tabs.
7. Carefully pull the assembly up
and out of pod.
8. Reverse the steps to install the
new housing and reassemble
the pod.
NOTE: The distance from the
headlamp parting line to the
end of the adjustment knob stop
is 5 1/8″ (13 cm). See illustration.
9. Adjust the headlight aim by
turning the adjusting knob.
5 1/8″
(13 cm)