Pioneer CNDV-40R - Manual (Page 88)

86
Chapter 5
Combining and Using Pioneer AV Equipment
TROL:INTERNAL” or the auxiliary “S.W. CON-
TROL:EXTERNAL”.
❒ Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 83) or subwoofer output
(refer to page 83) in the audio menu on.
❒ If you change the subwoofer controller, sub-
woofer output and non fading output in the
audio menu return to the factory settings.
❒ Both rear speaker leads output and RCA rear
output are switched simultaneously in this
setting mode.
1
Press
5 or ∞ to select “REAR SPEAKER”
from the INITIAL SETTINGS MENU, and
press the A.MENU (AUDIO) button.
2
Change the rear output setting with
5 or
∞.
Pressing
5 or ∞ will switch between “REAR
SPEAKER:FULL” (full-range speaker) and
“REAR SPEAKER:SUBWOOFER” (sub-
woofer).
❒ When no subwoofer is connected to the
rear output, select “REAR
SPEAKER:FULL”.
❒ When a subwoofer is connected to the rear
output, set for subwoofer “REAR
SPEAKER:SUBWOOFER”.
❒ When the rear output setting is “REAR
SPEAKER:SUBWOOFER”, you cannot
change the subwoofer controller.
3
Change the subwoofer controller with
2 2 2 2
or
3 3 3 3.
Pressing
2 2 2 2 or 3 3 3 3 will switch between “S.W.
CONTROL:INTERNAL” and “S.W. CON-
TROL:EXTERNAL”.
Switching the Muting/Attenua-
tion
When the navigation outputs the guidance voice,
or when a mute signal has been received from
the yellow/black lead connected to the Pioneer
AV Head Unit, the audio volume is muted or
attenuated.
This function is activated in the following condi-
tion:
— When “MUTE” or “ATT” is selected in the
mute setting.
— When “On” is selected in “Mute Setting”.
➲ Mute setting ➞ Page 51
❒ The sound is turned off, “MUTE” is displayed
and no audio adjustments are possible.
❒ The sound is attenuated, “ATT” is displayed
and no audio adjustments, except volume
control, are possible.
❒ Operation returns to normal when the phone
connection is ended or when the navigation
guidance and voice operation are ended.
❒ The guidance voice of navigation isn’t muted
or attenuated when a call is made or received.
1
Press
5 or ∞ to select “TEL/GUIDE
MUTE/ATT” from the INITIAL SET-
TINGS MENU, and press the A.MENU
(AUDIO) button.
2
Switch the muting/attenuation mode with
2
2 2 2 or 3 3 3 3.
MUTE : Volume is turned to 0.
ATT : Volume is set to 1/4.
NORMAL : Volume remains the same.