Pioneer CNDV-40R - Manual (Page 108)

106
Appendix
Messages and how to react to them
The following messages may be displayed by your Navigation System.
❒ There are occasions when you may see error messages other than those shown here. In such a
case, follow the instructions given on the display.
Message When What to do
You cannot use this function while
driving. While trying to make a menu selec-
tion. Pull over and come safely to a halt,
put the parking brake on, and then
try again.
This is not the appropriate disc.
Please insert the appropriate disc. • If you try to use a disc which is
incompatible with this system.
• If you insert a disc upside down.
• If the disc is dirty.
• If the disc is cracked or otherwise
damaged.
• Insert a suitable disc.
• Insert the disc with the label
upward.
• Clean the disc.
• Insert a normal, round disc.
Please insert the appropriate disc.
Irregular speed pulse signal is
detected. Please power off the sys-
tem and check the installation. After
you have checked, please re-boot the
system and press “OK”. If the Navigation unit does not
receive the vehicle speed pulse. Consult your Pioneer dealer.
Speed pulse wire is not connected.
System will start to learn without
speed pulse. Please keep in mind
that accuracy is not fully ensured
without speed pulse. The speed signal input (pink lead
wire) of the power cable is not con-
nected. To operate with 3D hybrid mode, con-
nect the speed signal input (pink
lead wire) of the power cable cor-
rectly.
Although it can be operated with
Simple hybrid mode without con-
necting the speed signal input, the
precision of the positioning will be
less accurate.
Vibration is detected. Please power
off the system and check the installa-
tion. After you have checked, please
re-boot the system and press “OK”. While the vehicle is stationary, the
Navigation System is installed in a
place where the navigation unit may
be affected by a large vibration. Re-install the navigation system in a
place where the navigation unit will
not be affected by vibration.
Direction of G sensor is not correct.
Please power off the system and
check the installation. After you have
checked, please re-boot the system
and press “OK”. Direction of G sensor is set incor-
rectly. See the “Installation Manual” and set
the direction of G sensor correctly.
Gyro Sensor is not working properly.
Please consult your dealer or Pioneer
service center. Abnormal output of the Gyrosensor
is detected. Note down the error code shown on
the screen; turn off the power, and
then contact your nearest Pioneer
service facility.
System detected vertical angle of the
installation has been changed.
Learning status for Gyro Sensor has
been initialized. In case the mounting angle of the
navigation unit is changed. The system initialises the sensor in
order to operate it with the maximum
performance and automatically
starts re-learning.
System detected that the vertical
angle of the installation exceeds the
permission level. Please install the
navigation unit correctly. The navigation unit is installed with
an extreme angle exceeding the limi-
tation of the installation angle. • Check the installation position of
your navigation system and the set-
ting of the Installation direction
lever
(Refer to “Installation Manual”).
• Confirm the installation angle. (The
navigation system must be
installed within +30 degrees to –15
degrees of the horizontal, or within
five degrees of your vehicle’s direc-
tion of travel.)
If time data has been lost it cannot
be saved to the PC Card. If this message is displayed, the
built-in battery of the navigation unit
might be running out. • Check that the GPS antenna is cor-
rectly connected.
• Consult the Pioneer Local dealer if
this message persists.