Pioneer CNDV-40R - Manual (Page 86)

84
Chapter 5
Combining and Using Pioneer AV Equipment
When the non fading output is on, you can adjust
the level of non fading output.
1
Press
5 or ∞ to select “NON FADING”
from the AUDIO MENU, and press the
A.MENU (AUDIO) button.
When the subwoofer controller setting is
“S.W. CONTROL:EXTERNAL”, you can
select non fading output on/off mode.
2
Press
5 to turn non fading output on.
❒ You can turn off non fading output by
pressing
∞.
3
Press
2 or 3 to adjust the output level of
the non fading.
Each press of
2 or 3 increases or decreases
the level of the non fading (e.g., + 6 to – 6).
Using the high pass filter
When you do not want low sounds from the sub-
woofer output frequency range to play from the
front or rear speakers, switch the HPF (high pass
filter) on. Only frequencies higher than those in
the selected range are output from the front and
rear speakers.
1
Press
5 or ∞ to select “HPF (HIGH PASS
FILTER)” from the AUDIO MENU, and
press the A.MENU (AUDIO) button.
2
Press
5 to turn high pass filter on.
❒ To turn high pass filter off, press ∞.
3
Press
2 or 3 to select a high pass filter
range.
Press
2 and “FREQUENCY:50Hz” is dis-
played. Press
3 and “80Hz”, “125Hz” is dis-
played. Only frequencies higher than those in
the selected range are output from the front
or rear speakers.
❒ If you switch the SFEQ mode, the HPF (HIGH
PASS FILTER) function is automatically
switched off. By switching the HPF (HIGH
PASS FILTER) function on after selecting
the SFEQ mode, you can combine the HPF
(HIGH PASS FILTER) function with the
SFEQ function.
Adjusting source levels
SLA (Source level adjustment) lets you adjust the
volume level of each source to prevent radical
changes in volume when switching between
sources.
❒ Settings are based on the volume level of the
FM tuner, which remains unchanged.
1
Compare the FM tuner volume level with
the level of the source you wish to adjust.
2
Press
5 or ∞ to select “SLA (SOURCE
LEVEL ADJUSTMENT)” from the AUDIO
MENU, and press the A.MENU (AUDIO)
button.
3
Press
5 or ∞ to adjust the source volume.
Each press of
5 or ∞ increases or decreases
the source volume.
❒ “LEVEL:+4” — “LEVEL:– 4” is displayed
as the source volume is increased or
decreased.
❒ Since the FM tuner volume is the control, it is
not possible to apply source level adjustments
to the FM tuner.
❒ The AM tuner volume level can also be
adjusted with source level adjustments.
❒ The CD and the multi-CD players are both set
to the same source level adjustment volume
automatically when using the AVH-P6400CD.
❒ External unit 1 and External unit 2 are set to
the same volume adjustment setting automat-
ically.