beautypg.com

Unregister handsets – Polycom SpectraLink SCM408 User Manual

Page 43

background image

Connect and Register Handsets

PN: 1725-36097-001_L.doc

43

Initially

Line 2

will flash. This is because

Line 1

is usually set up

as the remote access diagnostic modem. To register a handset

to

Line

1

, press the

STEP

button until

Line

1

flashes.

If the desired line already has a handset registered to it, follow

the procedure outlined below to unregister the handset, then

return to this step.

4. Turn on the handset to be registered by holding down the

PWR

key until the handset beeps twice. After a few seconds, the line

indicator LED on the MCU will shine solid red. Once the handset

is registered, the LED for the next line begins to flash.

5. To assign the extension number, hold down the

FCN

key until

Volume

Level

displays. Press the

# >

key until

EXTENSION

displays

on the handset. Press

0

, then enter the correct extension number.

Press

END

when finished.

6. Repeat steps 3 through 5 for all handsets to be registered.
7. When all handsets are registered, return the mode switch to the

NORMAL

position.

Unregister Handsets

If the desired line already has a handset registered to it, follow this

procedure to unregister the handset.
1. Move the mode switch on the MCU to the

REGISTER

position. If

your system has more than one MCU, be sure to move the switch

on the correct MCU. The

LINE

indicator LEDs now show which

lines have handsets registered.

2. Use the

STEP

button to select the line to be unregistered. The

LINE

indicator LED for a line that has a handset registered to it will

flash with the LED mainly on.

3. Press the

DEL/ENTER

button. The

LINE

indicator LED for the selected

line will be off with a short on flash

4. Register the new handset or return the mode switch to the

NORMAL

position.