Terminate cable at base station locations – Polycom SpectraLink SCM408 User Manual
Page 19
Run Cable for System
PN: 1725-36097-001_L.doc
19
Terminate Cable at Base Station Locations
After running the wire to the Base Station location, terminate the wire
using an RJ-45 modular crimp-on plug. Connect the data pair to pins
1 and 2, and the power pair to pins 7 and 8.
If the connection uses more than two pair, refer to the table on the
following page.
To avoid damage to the connectors or crimps, be sure to run the
wire to the Base Station before connecting the RJ-45 connectors.
RJ-45 Modular Cable
When wiring the 8-pin connector, use the following table as a guide.
8-pin Modular
Connector
MCU Pin
Function
Polarity
1
Data 1
Any
2
Data 2
Any
3
Power 3
+
4
Power 2
-
5
Power 2
+
6
Power 3
-
7
Power 1
-
8
Power 1
+
This manual is related to the following products:
- SpectraLink SCE408 SpectraLink SCT416 SpectraLink 1725-36097-001 SpectraLink SCA516 SpectraLink SCK416 SpectraLink SCA408 SpectraLink SCJ408 SpectraLink SCI416 SpectraLink SCN416 SpectraLink SCO416 SpectraLink SCJ416 SpectraLink SCO408 SpectraLink SCS416 SpectraLink SCI408 SpectraLink RCC400 SpectraLink SCK408 SpectraLink SCL408 SpectraLink RCU201 SpectraLink SCA416 SpectraLink SCL416 SpectraLink MOG400 SpectraLink SCM416 SpectraLink SCC408 SpectraLink SCC416 SpectraLink SCD416 SpectraLink SCF416 SpectraLink SCN408 SpectraLink SCE416 SpectraLink SCF4089 SpectraLink SCX416 SpectraLink SCD408