Polycom SpectraLink RCO400 - Manual (Page 53)

PN: 1725-36122-001_N.doc 53
System Initialization
Before the system can be tested or operated, the administration and
maintenance PC must be installed and connected to the MCU, the
system must be configured, and the handsets and Base Stations must
be registered. Refer to the SpectraLink 6300 MCU: Operator’s Console
document to perform the following steps, then return to the next
section to continue the installation procedures.
1. The PC must be connected to the system controller’s RS-232 serial
port. An optional modem should also be connected to a dedicated
phone line to provide remote access.
2. Load the administration software (Chk3000) and run the software.
3. Configure all system parameters.
4. Register all handsets.
5. Register all Base Stations.
6. Program macros on systems with analog interface.
7. Program handset features on the PBX.
If the system is connected to the telephone system via analog
lines, refer to the SpectraLink 6300 MCU: Operator’s Console
documentation.
If the SpectraLink 6300 MCU is connected to a digital key
telephone system or PBX, refer to the section of the LinkPlus
Interface Guide that deals specifically with the brand of telephone
system to which the SpectraLink 6000 System will interface.
7