Polycom SpectraLink RCO400 - Manual (Page 52)

SpectraLink 6300 MCU: Facility Preparation
PN: 1725-36122-001_N.doc 52
4. Place the Base Station inside the enclosure with the part number
label facing the back of the enclosure.
5. Screw the protective cover onto the Base Station enclosure.
Power Up and Check Diagnostics
Turn the power switch in the upper left of the Primary and Expansion
Shelves on.
After a slight delay, the lights on the cards will cycle through
diagnostic tests.
After testing completes, lamp 1 should flash green, indicating that the
card is running. If the Alarm light is red, there is a problem with the
system. Refer to SpectraLink 6300 MCU: Maintenance and Diagnostics
for troubleshooting information.