Polycom SpectraLink RCO400 - Manual (Page 43)

System Installation
PN: 1725-36122-001_N.doc 43
Run conduit to shelf
The shelves have two possible points of entry for conduit: on the side,
used for wall mounted shelves, or in the rear, used for rack mounted
shelves.
Select the point of entry (side or rear) for this installation and unplug
the correct opening on each shelf to be installed.
For each shelf:
1. Attach the conduit entry hardware (condulet) to the conduit.
2. Pull the conduit through the hole.
Connect wire to terminals
Connect the wire to the terminal strip and grounding stud, as shown
in the following illustration. Position the wires to be flat against the
back of the shelf.