Promise Technology VTrak 15110 - Manual (Page 64)

VTrak 15110 User Manual
56
Log-out of WebPAM PRO
There are two ways to log out of WebPAM PRO:
•
Close your browser window
• Click Logout on the WebPAM PRO banner (below)
After logging out, you must enter your username and password to log in again.
Clicking Logout brings you back to the Login Screen.
Internet Connection using WebPAM PRO
The above instructions cover connections between VTrak and WebPAM PRO
over your company network. It is also possible to connect to a VTrak from the
Internet.
Your MIS Administrator can tell you how to access your network from outside the
firewall. Once you are logged onto the network, you can access the VTrak using
its IP address.
Please note that only the PC with the SCSI connection can read and write data to
the logical drives on the VTrak. However, other PCs can monitor the VTrak from
virtually any location.
Caution
Conflicting ID numbers can prevent WebPAM from connecting to
the RAID subsystem and/or cause the SCSI HBA BIOS not to
recognize the Logical Drives. Promise offers a sufficient quantity
of TIDs and LUNs to avoid any conflict problems.
Note
The quantity and ID number of Target IDs you select depends in
part upon how many logical drives you plan to create, how your
Host PC and RAID subsystem are connected, and how many
addresses are on the SCSI bus.