Promise Technology VTrak 15110 - Manual (Page 111)

Chapter 4: Management with WebPAM PRO
103
To set an alias for this controller or to set VTrak's date and time, click the Settings
tab.
To access the Controller–Information tab:
1. Click the Subsystem icon.
2. Click on the VTrak icon.
3. Click on the Controllers icon.
4. Click on the Controller icon.
Controller Parameters
• Controller ID – (typically 1).
• Alias – A user-specified name given to this controller.
• Vendor – Promise Technology, Inc.
• Model – Model number of this VTrak.
• Serial Number – Serial number of this VTrak
• Memory Size – Size of VTrak's cache memory in MB.
• Flash Size – Size of VTrak's flash memory in MB.
• NVRAM Size – Size of VTrak's non-volatile RAM memory in MB.
• SEP Hardware Version – Hardware version number of the Storage
Enclosure Processor (SEP) card.
• Hardware Version – Hardware version number of the Controller card.
• Firmware Version – Revision number of the currently installed VTrak
firmware.
• Firmware Build Date – Date and time setting of the VTrak subsystem.
• Maximum supported numbers:
•
Disk Arrays – Organized collections of physical drives.
• Logical Drives – Entity based on a disk array that the PC's operating
system recognizes as a single disk drive.
• Physical Drives – Hard disk drives.
• Dedicated Spares – A hot spare drive available only to a specified disk
array.
Settings
The Controller–Settings tab enables you to specify an alias (name) for this
controller and set the VTrak subsystem's date and time.
To set an alias for this controller: