Promise Technology VTrak 15110 - Manual (Page 182)

VTrak 15110 User Manual
174
Gateway IP Address: 10.0.0.3
-------------------------------------------------------------------------
Management Port
1. DHCP
2. Management Port IP
3. Subnet Mask
4. Gateway
R. Return to Previous Menu
Please enter your menu choice>1
2. Press 2 and Enter to select Management Port IP.
--------Configure Management Port IP address--------
Current management port IP Address: 10.0.0.2
Modify management port IP address(y/n)?>y
New management port IP address>192.168.1.56 (an example only)
New management port IP address: 192.168.1.56
Press Enter key to return
3. Press Y and Enter to modify the management port IP address.
4. Type the new IP address and press Enter.
VTrak confirms the new address.
5. Press Enter to return to the Network Management menu.
6. Repeat steps 2 through 5 to set the Subnet Mask and Gateway IP address
7. Reboot the VTrak for these changes to take effect.
Telnet
Telnet allows you to use the CLU to manage VTrak over a network. The Telnet
screen looks the same as the CLU screen, except that you have to log in. You
must enable Telnet on VTrak before you can establish a Telnet connection.
Enable/Disable Telnet
1. Press 2 and Enter to access the Telnet settings.
Current Telnet settings:
Telnet: enabled
Timeout: 600 seconds
Port: 2300
User Name: administrator
---------------------------------------------------
Telnet Settings
1. Enable/disable Telnet