Promise Technology VTrak 15110 - Manual (Page 109)

Chapter 4: Management with WebPAM PRO
101
2. Click on the VTrak icon.
3. Click on the Service Management icon.
4. To access SNMP settings, click the SNMP tab or SNMP link.
5. To access Telnet settings, click the Telnet tab or Telnet link.
There are no user settings for CIM.
SNMP
The Service Management–SNMP tab enables you to specify SNMP settings.
Simple Network Management Protocol (SNMP) is a set of protocols for managing
complex networks. SNMP works by sending messages to different parts of a
network. SNMP-compliant devices called "agents" store data about themselves
in Management Information Bases (MIB) and return this data to the SNMP
requesters. Event notifications called "traps" are sent to a destination or "trap
sink" specified by an IP address.
To enable SNMP:
1. Click the Subsystem icon.
2. Click on the VTrak icon.
3. Click on the Service Management icon.
4. Click on the SNMP tab.
5. Enter a System Name.
6. Enter a System Location.
7. Enter a System Contact.
8. Enter a name for the Read Community.
9. Enter a name for the Trap Community.
10. Enter a Trap Sink IP address.
11. Click the Update button.
The new trap sink will appear in the list.
12. Click the Submit button when you are done.
To delete a trap sink:
1.
In the Trap Sinks list, check the Delete box for the trap sink you want to
delete.
2. Click the Delete button.
3. Click the Submit button when you are done.