Network management, Management port – Promise Technology VTrak 15110 User Manual
Page 181
Chapter 5: Management with the CLU
173
Network Management
From the Main Menu, press 5 and Enter to access Network Management.
The Network Management menu displays with the factory default settings shown
above it.
Network Parameters:
DHCP: Enabled
Telnet: Enabled
TFTP Server IP Address: 192.168.10.5
SNMP Name: priti
SNMP Location: usa
---------------------------------------------------------------
Network Management
1. Management Port
2. Telnet
3. TFTP Server
4. SNMP
5. Ping
R. Return to Previous Menu
Please enter your menu choice>
Management Port
Use this feature to change the IP addresses for VTrak’s Management port and
Gateway plus the Subnet Mask. You can make these settings manually. If your
network has a DHCP server, you can enable DHCP on VTrak and the
Management Port settings will be handled automatically.
To enable DHCP:
1.
From the Network Management menu, press 1 and Enter to access the
Management Port menu.
2.
Press 1 and Enter to access DHCP.
3.
Press Y and Enter to enable DHCP on VTrak.
4.
Press Enter again to return to the Management Port menu.
To make settings manually:
1.
From the Network Management menu, press 1 and Enter to access the
Management Port menu.
The Management Port settings display.
--------------------------------------------------------------------------
Management Port IP Address: 10.0.0.2
Subnet Mask: 255.0.0.0