Room monitoring with the v500 web interface, Room monitoring with the v500 web interface - 3 – Polycom Audio and Video User Manual
Page 75
Chapter 5 - Managing the System Remotely
© Polycom, Inc.
5 - 3
Room Monitoring with the V500 Web Interface
The Web Director feature within the V500 web interface allows administrators of
the V500 system to monitor a call or the room where the system is installed.
For security reasons, this feature can only be enabled on the local system by an
administrator.
To enable room monitoring:
1.
Go to System > Admin Settings > General Settings > Security.
2.
Select Allow Video Display on Web to allow the room to be viewed remotely.
To view a room:
1.
On a PC, open a web browser.
2.
In the browser address line, enter the system’s IP address (for example,
http://255.255.255.255
) to go to the V500 web interface.
3.
Go to System Setup > Utilities > Web Director.
4.
Perform any of the following tasks:
•
Place or end a call
•
View near and far sites
•
Adjust system volume settings
•
Mute and unmute the microphone