General troubleshooting, Power and start-up, General troubleshooting - 8 – Polycom Audio and Video User Manual
Page 100: Power and start-up - 8
Administrator’s Guide for the V500 System
7 - 8
www.polycom.com/videodocumentation
General Troubleshooting
This section presents problems, likely causes, and corrective actions. Problems are
grouped as follows:
❑
❑
❑
❑
❑
❑
❑
❑
❑
Power and Start-up
Symptom
Problem
Corrective action
The system does not
start or respond in any
way
The power switch is off.
Turn on the power switches for the system and any
equipment connected to it.
The power cord is not
connected.
Make sure the power pack is connected to a power outlet,
and that its power cords are seated securely.
The power outlet is not
active, or the system’s
power supply is not
operating properly.
Check the power outlet by unplugging the system and
plugging in a lamp, radio, or other small appliance. If it
does not operate, the outlet is not active — connect the
system to a different outlet.
If the outlet is active, the problem is in the system’s power
supply. In this case, call Polycom Technical Support and
arrange to return the system for service.
The system starts in the
software update screen
The system software is
corrupted or not loaded
properly.
Load the system software from your PC. For instructions
on how to do this, refer to
The system restarts over
and over
The power supply is bad.
Return the system for service.
The socket is corroded.
Unplug and reseat the power plug 5 times.