Promise Technology VTrack M-Class M200i User Manual
Page 282
VTrak M-Class Product Manual
274
Drive-interface controller
is NOT found
Restart the VTrak. See page 218. If this message
appears repeatedly, contact Technical Support. See
page 299.
Drive-interface
diagnostics has passed
Normal.
Drive-interface
diagnostics has failed
Restart the VTrak. See page 218. If this message
appears repeatedly, contact Technical Support. See
page 299.
Drive-interface controller
has generated a general/
data parity error.
Drive-to-controller parity error. If this message
appears repeatedly, contact Technical Support. See
page 299.
Enclosure
Enclosure temperature is
above the threshold/
warning threshold
The VTrak is overheating. Check for airflow around
and through the VTrak, and verify that all fans are
working. Replace fans as needed.
Enclosure temperature is
above the critical
threshold
The VTrak is seriously overheating. Check for airflow
around and through the VTrak, and verify that all fans
are working. Replace fans as needed.
Enclosure temperature is
within the normal range
Normal.
Event Log
Event logging is enabled
Event logging has been successfully enabled.
Event logging is disabled
Event logging has been disabled.
Event log buffer is cleared
in RAM
The event log was cleared.
Event log buffer is cleared
in NVRAM
The non-volatile RAM event log was cleared.
Event log buffer is cleared
in MDD
The MDD (disk drive) event log was cleared.
Host Interface Controller
Host-interface controller
has detected parity/data
parity/command parity
error
A FC/iSCSI error occurred. If this message appears
repeatedly, contact Technical Support. See
page 299.
Event
Action