Event notification response – Promise Technology VTrack M-Class M200i User Manual
Page 279

Chapter 8: Troubleshooting
271
Event Notification Response
When you select Event Notification, WebPAM PROe sends popup and/or email
messages regarding its status. The messages you see depend on your
notification selection (see page 77) and what is currently happening in the VTrak.
The chart below gives the suggested action when the corresponding message is
displayed. A list of major categories is shown below.
•
•
•
•
•
•
Drive Interface Controller
(page 273)
•
•
•
Host Interface Controller
(page 274)
•
•
•
•
•
Online Capacity Expansion
(page 277)
•
•
•
PSU (Power Supply Units)
(page 280)
•
•
RAID Level Migration (page 281)
•
•
•
•
•
•
•
Stripe Level Migration (page 284)
•
•
•
•
Event
Action
Battery
Battery temperature is
above the threshold
The battery is too hot. Verify proper airflow around
the through the VTrak. If airflow is OK, replace the
battery. See page 230 or page 233.
Battery temperature is
normal
Normal.
Battery capacity is below
the threshold
Battery is drained. Run battery reconditioning. See
page 121.
Battery capacity is normal Normal.
Battery is discharging
Battery is undergoing reconditioning.