Line 6 POD X3 Family - Manual (Page 37)

Reference: Tweaking Tones
3•5
Tap – set this to OFF to have this effect ignore tempo, or pick a note value that you’d like your speed to
match; works with the Tap button/footswitch and the Tempo knob.
Tempo – Shows the tempo that’s been set by Tap, and lets you fine tune it.
Mix – controls the ratio of wet (effected) to dry (non-effected) sound that is heard.
Depth – controls the overall amplitude of the modulating wave, which usually determines just how
intense the effect will be.
Bass – bass tone control.
Treble – treble tone control.
Config – allows you to choose the position of the Mod pedal in your signal flow: Pre (before the amp
model), or Post (after the amp model).
Fdbk – adjusts how much of the effected signal is fed back to the input of the effect.
Manual – on Jet Flanger, controls the length of the very short delay that’s applied to the sweep to make
the flanging effect happen.
Wave – adjusts shape of the waves that drive the Tremolos and Auto Pan.
Tone – overall tone control.
Predly – adjusts how long it takes for the effect to kick in.
Q – adjusts tone focus from sharp to broad.
Freq – changes the frequency that the effect is focused on.
Flut – adjusts the amount of tape-style flutter for Tape Eater.
Dist – distortion, baby!