3 block move instruction, 1 first dword, Block move instruction – LSI 53C875A User Manual
Page 206: First dword, Section 5.3.1, “first dword
5-6
SCSI SCRIPTS Instruction Set
5.3 Block Move Instruction
Performing a Block Move instruction, bit 5, Source I/O - Memory Enable
(SIOM) and bit 4, Destination I/O - Memory Enable (DIOM) in the
register determines whether the source/destination
address resides in memory or I/O space. When data is being moved onto
the SCSI bus, SIOM controls whether that data comes from I/O or
memory space. When data is being moved off of the SCSI bus, DIOM
controls whether that data goes to I/O or memory space.
5.3.1 First Dword
IT[1:0]
Instruction Type - Block Move
[31:30]
The IT bit configuration (00) defines a Block Move
Instruction Type.
IA
Indirect Addressing
29
This bit determines if addressing is direct or indirect.
If IA bit is (0), use destination field as an address (direct
addressing). If IA bit is (1), use destination field as a
pointer to an address (indirect addressing).
When this bit is zero, user data is moved to or from the
32-bit data start address for the Block Move instruction.
The value is loaded into the chip’s address register and
incremented as data is transferred. The address of the
data to move is in the second Dword of this instruction.
When this bit is one, the 32-bit user data start address
for the Block Move is the address of a pointer to the
actual data buffer address. The value at the 32-bit start
address is loaded into the chip’s
register using a third longword fetch (4-byte
transfer across the host computer bus).
31 30 29 28
27
26
24 23
0
Register
Register
IT[1:0] IA TIA OPC SCSIP[2:0]
Transfer Counter [23:0]
0
0
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x
x