Scsi wide residue (swide), Register: 0x45, Register: 0x46 – LSI 53C875A User Manual
Page 173
SCSI Registers
4-81
Which byte is accessed is controlled by the SLPHBEN bit
in the
register.
Register: 0x45
SCSI Wide Residue (SWIDE)
Read/Write
SWIDE
SCSI Wide Residue
[7:0]
After a wide SCSI data receive operation, this register
contains a residual data byte if the last byte received was
never sent across the DMA bus. It represents either the
first data byte of a subsequent data transfer, or it is a
residue byte which should be cleared when an Ignore
Wide Residue message is received. It may also be an
overrun data byte. The power-up value of this register is
indeterminate.
Register: 0x46
Memory Access Control (MACNTL)
Read/Write
TYP
Chip Type
[7:4]
These bits identify the chip type for software purposes.
Note:
These bits no longer identify an 8XX device. These bits
have been set to 0xF to indicate that the device should be
uniquely identified by setting the PCI Configuration Enable
bit in the
register and using the
PCI Revision ID and PCI Device ID which will be shadowed
in the
register. Any devices
that contain the value 0xF in this register should use this
mechanism to uniquely identify the device.
7
0
SWIDE
x
x
x
x
x
x
x
x
7
4
3
2
1
0
TYP
DWR
DRD
PSCPT
SCPTS
1
1
1
1
0
0
0
0